Be sure the hold-down cone is hand tight and is centered in the rim. As the tapered end of the cone enters the rim center hole, the wheel will adjust itself onto the conical top. Thread the hold-down cone clockwise on center post. BEAD LOOSENING AND DEMOUNTING Place the tire and wheel on the conical table with the narrow side of bead seat up and with tire valve located on operator s side of the machine at 6 o clock. Current list is as follows: Pin extension weldment Shaft extension weldment Dismount boot Mounting boot II.
Check that standard accessories are on hand. It should always return to this location at the end of a complete cycle.ģ 8. It should point to the right-hand corner of the table for operator convenience. Check the location of the stub of the center shaft when at rest. Add approved tire lube mixture to the lube bottle at this time. THE AIR SYSTEM MAY CONTAIN FOREIGN PARTICLES. CAUTION: STAND CLEAR OF THE AIR BLAST RING ON THE TABLE IF AIR BLAST CAPABILITY IS BEING TESTED WITHOUT A TIRE/WHEEL OVER IT. Check air blast and air inflation operations with deflated tire on the table. FMC offers the Air Filter Kit under part no Cycle machine and ensure smooth operation in both forward and reverse directions of travel. To extend the service life of the air operated components, the addition of a Filter/Oiler is recommended. Do not place hands near machine, because it will cycle when air is applied.
(maximum of 180 p.s.i.) is required at machine. Connect 3/8" air supply line to 150 psi source. Inspect for any possible shipping damage. Remove tire changer from shipping pallet (optional). Remove carton, blocks, and machine protection. 1 Model 7600/7700 Tire Changer Operators Manual FormĢ MODEL 7600/7700 TIRE CHANGER OPERATORS MANUAL TABLE OF CONTENTS I.
0 kommentar(er)
